HilverdaKooij 1430 AA Aalsmeer Holland T: +31 297 382038 F: +31 297 382020 E: info@hilverdakooij.nl I: www.hilverdakooij.nl LIMONIUM SINUATUM 'STATICE'
Botanical family : Plumbaginaceae. genus: limonium species: sinuatum common name : 'statice' The great success of limonium and the increasing interest for limonium made HilverdaKooij decide to develop their own limonium varieties. In the past few years HilverdaKooij's Breeding Section developed various new limonium sinuatum species called the 'WINGS'‐series. The HilverdaKooij 'Wings‐series' is available in a wide range of new bright/intensive colours and suitable for glasshouse as well as outdoor cultivation. All over the world limonium species can be found. At present some 200 species have been identified. Nowadays several of these are used for both fresh cut flower and dried flower production. limonium sinuatum or 'annual statice' originates from the mediterranean coastal areas. Therefore all varieties have been adjusted to grow in a dry environment. The tiny flowers are narrow funnel shaped, consisting of loose terminal panicles appearing in loose bows. The leaves of the sinuatum plants form a rosette pattern at the base of the plant, the leaves grow close to the ground. Prior to flowering the stem elongates and terminal leaves become upright. Stems are winged and grow approx. 70‐80 cm tall when flowering. TISSUE CULTURE
Until 1989 almost all limonium sinuatum or 'notch leaf statice' was reproduced by seed, and only available in blue‐purple and white colours. Seed propagated statice is usually planted with 12 plants/net m² or 8.5 plants/gross m². Unfortunately the plants are not very uniform and production per plant is relatively low. From the first research it appeared that the 'in vitro propagation' of limonium sinuatum is difficult. Recently the experience with tissue culture is at such a level that the propagation of limonium sinuatum can be done successfully: producing uniform plants which are 100% free of fungal diseases. The newly developed Tissue Culture method enabled the rapid introduction of a wide range of new varieties. The reproduction by Tissue Culture guarantees that all characteristics of the variety remain in the young plants. The new varieties are selected for their 'special' colours and uniform growth. Especially growing characteristics as a uniform stem length, a higher production and a better quality of the flowers are used for selection: resulting and a higher production from less plants per square meter. HilverdaKooij
cultural directions ‘Wings’‐series
PLANTING
For the cultivation of statice any type of soil is suitable. The soil should be well drained; sandy or sandy‐clay soils are recommended. The soil must be free of pests and diseases. When necessary we advise to fumigate or to steam sterilise. This will also control possible weed problems. It is important that the growing points (eyes) of the plants can be reached by light. The plants should not be planted too deep and the eyes should not be covered by soil. FERTILIZATION
Generally statice needs a limit amount of fertilizer especially when grown in the greenhouse. For greenhouse cultivation the soil is normally fertile enough. This also depends on the soil type where the crop is being grown on. If the soil contains too many nutrients the crop may become very flaccid with a decrease in flower production. Basic fertilization before planting the crop: 3‐5 kg sulphate of potash magnesium
Use as fertilizers organic materials or late effect (slow working) chemicals. After the first flush is harvested liquid fertilizers can be given as follows: N:P:K
After the above fertilization, give clean water to optimise the uptake of the solution given. Watering is necessary until flower bud initiation. Listed below is a guideline of nutrient elements needed for annual statice in mill mole ( m/mol ) per litre water. Ammonium (NH +
A soil pH of 6.5 and an EC of 1,0 is ideal for the cultivation of statice. PLANTING DISTANCE
The advised planting distance between each plant is 30 x 30 cm. It is recommended to plant two rows per bed, each bed should be 1 meter wide with paths of at least 40 cm wide in between the beds. Use one layer of 17x20 cm mesh/ support wire. Do not plant too deep; it is important that the growing points (eyes) of the plants are not covered by soil. 6 plants per net m² = 3 ‐ 3.5 plants per gross m² Planting more plants per square meter will result in more stems per sq meter but a lower quality. HilverdaKooij
cultural directions ‘Wings’‐series
PLANTING IN NORTHERN AND SOUTHERN EUROPE
Due to the difference of the climates in Northern and Southern Europe a different planting strategy can be followed. Northern Europe:
Planting can take place from the end of December (in heated glasshouse) until mid June. Outdoor planting can take place as from April till the end of May. From the 'early' planting, flower production can be expected at the end of April to beginning of May. A spring planting usually flowers 10‐11 weeks after planting. If the grower wishes to plant early e.g. December/February it is necessary for the temperature in the greenhouse to be apx. 12‐14°C at night. If sunny the temperature may rise to 20‐25°C, the greenhouse must be ventilated at a temperature higher than 15‐16°C.
Planting can take place from August to February; however keep plants frost‐free at all times. When planting in August/September, flower production can be expected from October onwards.
CULTIVATION The growth of statice is very much light depending. A day length of 14 hours or more promotes earlier flowering and better quality flowers. For planting under extreme sharp light conditions a maximum 40% shade cloth can be applied. As soon as the plants are well established the shade net should be removed. In Summer the plants will start generative growth soon after planting. These first flower stems should be pinched until the plant has a rosette with a diameter of at least 25‐30 cm, as well as a sufficient vegetatively developed plant. The plants are sensitive to a high moisture content. A high humidity in the greenhouse must be avoided, especially during the flowering period. Ventilation of the greenhouse is necessary 24 hours a day during flowering. A high humidity may cause an outbreak of Botrytis in the flowers. TEMPERATURE
Temperature is an important cultivation aspect for limonium sinuatum. The Vernalization and Devernalization of plants are regulated by temperature. HilverdaKooij
cultural directions ‘Wings’‐series
CULTIVATION TEMPERATURE
In case of Winter planting the greenhouse must be kept frost free. From January onwards the greenhouse must be kept at minimum 10 °C. Ideal greenhouse temperature for statice :
The most suitable night temperature is 12‐14 °C.
planted in winter (December ‐ January)
Second flush It may be necessary to pinch the first new flower stems which appear soon after the end of the first flush. This so‐called 'flush‐in‐between' is often too short and of inferior quality and should be completely pruned in mid summer. Depending on the local climatological conditions you may chose to proceed for the second flush in following manner:
After the peak of first flush has decreased
Within a few weeks the first new stems of
second flush will appears. The quality of
difference between day and night tempera‐
well into autumn as long light and tempe‐
sufficient leaves ‐ plant diameter apx
30/40 cm ‐ and pinch again the first flower stems. When the plant is well developed allow the flower stems to grow.
note: In the second half of the year vegetation heating or a hot air cannon should be used to lower the humidity in the greenhouse and keep the crop dry, so a possible outbreak of Botrytis is prevented.
HilverdaKooij
cultural directions ‘Wings’‐series
WATERING
Careful watering is the most important aspect for a successful Statice sinuatum crop. The grower should determine whether or not the crop needs water by the condition/quality of the crop. We advise to water the plants until a rosette is formed with the use of a sprinkler or overhead watering system. Hereafter the plants should be watered by drip irrigation tubes which run down the bed. Two drip tubes should be used for every bed. From flower bud initiation till harvesting time water as required. If possible add fertilizer. Continue watering throughout the crop. Although just before flowering starts a decrease in water application does stimulate flowering. It is very important that special care is taken from flower induction until harvesting. The flowers should not come into contact with water at all as they are most susceptible to Botrytis at this stage. Water tends to remain in the funnel shaped flowers creating an ideal situation for an outbreak of Botrytis. Botrytis is the most harmful disease which can occur in a flowering limonium sinuatum crop. HARVESTING
The flowers can be harvested when the outer, coloured, petals are open as well as the inner white flower. Harvesting should be done in the early morning or in the late afternoon. In the harvesting period good ventilation is necessary to prevent condensation and to maintain a low moisture content in the glasshouse. The first stems can be harvested approx. 3 months after planting; between April ‐ May. Within the varieties there can be a difference of 7 ‐ 14 days. The daily temperature is mainly responsible for the flower bud initiation. Whereas long days promote a rapid growth of the flowers. Stems should be cut using small scissors or a sharp knife. Flowers do not open any further once placed in water which is why it is advised to pick flowers only when they are as ripe as possible. DISEASES
Never use DDVP, this will cause burning of the crop ! Botrytis The most occurring disease in limonium is Botrytis. Botrytis cinerea or grey mould is a fungus that forms on leaves or the flowers causing irreversible damage. Conditions encouraging Botrytis are a high humidity and a high moisture content of the soil. When the humidity level is over saturation point (100% relative humidity) the air cannot hold any more moisture and condensation will occur. It is only in the presence of free standing water that Botrytis spores germinate if the temperature is above 5‐6°C. Early symptoms of Botrytis are yellow leaves, loss of foliage, small white or brown spots on the petals and leaves (in dark coloured petals the spots are brown and soft; in light coloured petals they are white and circular). Once these spots develop into fuzzy grey mould, the spores are released into the air infecting the surrounding flowers. HilverdaKooij
cultural directions ‘Wings’‐series
‐ Refrigerated units should not be above 5°C.
‐ Wet flowers should never be placed in the cold room.
‐ Bunches should be bunched loose enough so that the moisture released by transpiration from the foliage can evaporate. ‐ Any damaged, diseased or decaying flower or foliage should be removed as they are very vulnerable to an outbreak of Botrytis. ‐ Whatever the flowers come into contact with e.g. containers, buckets etc. should be clean.
‐ spray 1 gr. Fongarid per m² after planting
‐ spray 200 gr. Rovral per 100 liters water + 30 cc
‐ or, spray 100 gr. Rizolex /100 l water
‐ or, spray 150 gr. Eupareen /100 l water
‐ or, spray 200 gr. Benlate /100 l water
‐ or, spray 200 gr. Mancozeb /100 l water
‐ or, spray 200 gr. Ronilan /100 l water
spray using a low volume high pressure spray !!
Sclerotinia
Rhizoctonia
‐ 100 gr. Rizolex, after spraying, rinse/wash off with clean water
Red spider mite
Spray once every 7‐10 days(per 100 liters water):
‐ or, Talstar 40 ml (only in glasshouse)
HilverdaKooij
cultural directions ‘Wings’‐series
Cutworm, Caterpillars etc
Scutigerella
Prepare the soil mix in the Curater. After adding Curater to the soil drench by watering using lots of water to break down the Curater.
Beatles, Taxusbeatle Spray once per week and repeat this for some weeks, hereafter 1x per 14 days, repeat this 1x 14 days 2‐3 times.
‐ or, Parathion 100 ml, before adding, the soil should be
moist, thereafter rinse, wash off the Parathion by
Soil treatment with Curater, rinse and drench soil hereafter
Rust spray:
* HilverdaKooij can not be held responsible for the result/effect on a crop due to the advice and the information in the growing manual.
HilverdaKooij
cultural directions ‘Wings’‐series
S.P.R. Rose1 Professor of Biology and Director, Brain and Behaviour Research Group, The Open University, Milton Keynes MK7 6AA, U.K. colleagues in the Science Faculty of the Open Universitywho have over the past 33 years struggled with the toughart of communicating science in public – and to a publicabout whom no preconceptions were permitted except thatof their commitment to learning. In
Action Research: The Alberta Initiative for School Improvement (AISI) and its Implications for Teacher Education Jim Parsons Professor, Department of Secondary Education, Faculty of Education, University of Alberta, Larry Beauchamp Professor, Department of Secondary Education, Faculty of Education, University of Alberta, Canada. Abstract This paper reviews data from four